Siemens simatic ET 200MP - Marking the I;O Modules; Labeling Strips

Wiring
6.9 Marking the I/O modules
ET 200MP Distributed I/O System
74 System Manual, 01/2013, A5E03723484-01
6.9 Marking the I/O modules
6.9.1 Labeling strips
Introduction
Mark the pin assignment of the I/O modules using labeling strips. The labeling strip can be
written on as desired, and is slid into the outside of the front cover.
The labeling strips are available in the following models:
● Ready-made strips for manual inscription, that are included with the module in the
delivery condition.
● DIN A4 sheets, pre-perforated strips for machine printing. See the chapter Accessories /
Spare Parts (Page 113).
Preparing and installing the labeling strip
1. Label the labeling strip.
2. With a pre-perforated strip: Separate the labeled strip from the sheet.
3. Slide the labeling strip into the outside of the front cover.

① Labeling strips
Figure 6-9 Marking with labeling strips