Siemens simatic ET 200MP - Page 73

Wiring
6.8 Front connector for the I/O modules
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
73
Bringing the front connector directly into final position
1. Grip the front connector by the unlocking strap.
2. Push the guide pins of the front connector into the guide channel that has been displaced
downwards. The front connector slides over the guide channel into its final position.
Figure 6-8 Bringing the front connector directly into final position
3. Tilt the front connector and press it into the module until it latches. The front connector is
now electrically connected with the module.
4. Swivel the front cover down into place. Depending on the space requirement of the cable
harness, various latch positions are possible, so that the required cable storage space
can grow as needed.
Reference
Further information on wiring can be found in the Product Manuals for the I/O modules.