Siemens simatic ET 200MP - 10 Technical Specifications; Standards and Approvals

ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
95
Technical specifications
10
10.1 Standards and approvals
Introduction
Contents of general technical specifications:
● The standards and test values that the ET 200MP distributed I/O system complies with
and fulfills
● The test criteria according to which the ET 200MP was tested
Note
Information on the components of the ET 200MP
The current valid markings and approvals are printed on the components of the
ET 200MP.
Technical specifications for the modules
The technical specifications of the individual modules can be found in the manuals for the
respective module. In the event of deviations between the statements in this document and
the manuals, the statements in the product manuals take priority.
Reference
The certificates for the markings and approvals can be found on the internet under
Service&Support (http://www.siemens.com/automati
on/service&support).
Safety information
WARNING
Personal injury and damage to property may occur.
In potentially explosive atmospheres, injury to persons and material damage may occur if
you disconnect plug-in connections during operation of an ET 200MP.
Always switch off the power to the ET 200MP when disconnecting plug-in connections in
potentially explosive atmospheres.