Technical specifications
10.1 Standards and approvals
ET 200MP Distributed I/O System
96 System Manual, 01/2013, A5E03723484-01
WARNING
Explosion hazard
If you replace components, compliance with Class I, DIV. 2 could be compromised.
WARNING
Area of application
This device is only appropriate for use in Class I, Div. 2, Group A, B, C, D, or in non-
hazardous areas.
CE mark
The ET 200MP distributed I/O system meets the requirements and protection targets of the
following EC guidelines and complies with the harmonized European standards (EN) for
programmable logic controllers published in the official gazettes of the European
Community:
● 2006/95/EC "Electrical Equipment Designed for Use within Certain Voltage Limits" (Low-
Voltage Directive)
● 2004/108/EC "Electromagnetic Compatibility" (EMC Directive)
● 94/9/EC on "equipment and protective systems for use in hazardous areas" (explosion
protection directive)
The EC declaration of conformity is held on file available to competent authorities at:
Siemens Aktiengesellschaft
Industry Sector
I IA AS FA WF AMB
Postfach 1963
D-92209 Amberg, Germany
These files are also available for download on the Customer Support internet pages, under
the keyword "Declaration of Conformity".
To Next Page
Loading...
