EasyManuals Logo

Siemens simatic ET 200MP System Manual

Siemens simatic ET 200MP
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Table of contents
ET 200MP Distributed I/O System
6 System Manual, 01/2013, A5E03723484-01
6.5 Connecting supply voltage to the interface module .................................................................... 58
6.6 Connecting supply voltage to the power supply module............................................................. 59
6.7 Conn
ecting PROFINET IO via the RJ45 bus connector to the interface module ....................... 61
6.8 Front connecto
r for the I/O modules ........................................................................................... 63
6.8.1 Characteris
tics of the front connector ......................................................................................... 63
6.8.2 Wiring
front connectors for I/O modules without shield contact element.................................... 64
6.8.3 Wiring
front connectors for I/O modules with shield contact element......................................... 66
6.8.4 Bringing the front connec
tor into final position............................................................................ 72
6.9 Marking the I/O modules
............................................................................................................. 74
6.9.1 Labeling strips
............................................................................................................................. 74
6.9.2 Optional marking ........................................................................................................
................. 75
7 Configuri
ng .............................................................................................................................................. 77
7.1 Select
ion of the power supply (PS) module................................................................................ 77
7.2 Selection of the load power supply
(PM) .................................................................................... 78
8 Commissioni
ng ........................................................................................................................................ 79
8.1 Commissioning the ET 200 MP
.................................................................................................. 79
8.2 Startup of the ET 200MP...................................................................................................
.......... 80
8.3 Identification data
........................................................................................................................ 81
8.3.1 Reading out and entering I
&M data ............................................................................................ 81
8.3.2 Reco
rd structure for I&M data..................................................................................................... 82
8.4 Protection by
locking the interface module ................................................................................. 84
9 Maintenance
............................................................................................................................................ 85
9.1 Removing and inserting I/O modules........................................................................................
.. 85
9.2 Replacement
of I/O modules and front connectors .................................................................... 86
9.2.1 Coding elem
ent on the I/O module and on the front connector.................................................. 86
9.2.2 Replacing an
I/O module............................................................................................................. 88
9.2.3 Replacing a front c
onnector ........................................................................................................ 89
9.3 Coding elem
ent on the power connector of the power supply module....................................... 90
9.4 Firmware update ...........................................................................................................
.............. 92
9.5 Resetting interface module to factory sett
ings............................................................................ 93
10 Technical
specifications........................................................................................................................... 95
10.1 Standards and approvals ..................................................................................................
.......... 95
10.2 Electromagnetic
compatibility ................................................................................................... 100
10.3 Shipping and st
orage conditions............................................................................................... 102
10.4 Mech
anical and climatic ambient conditions............................................................................. 103
10.5 Information o
n insulation, protection class, degree of protection and rated voltage ................ 105
10.6 Use of the ET 200MP in zo
ne 2 potentially explosive atmospheres......................................... 106

Table of Contents

Other manuals for Siemens simatic ET 200MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens simatic ET 200MP and is the answer not in the manual?

Siemens simatic ET 200MP Specifications

General IconGeneral
BrandSiemens
Modelsimatic ET 200MP
CategoryI/O Systems
LanguageEnglish

Related product manuals