Configuring the device
5.12 Configuring Autostart or wait time
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
59
Configuring Autostart or wait time
You specify in the "System Control/Info" dialog whether the project starts immediately after
the device powers up or after a wait time.
Touch the "System Control/Info" icon.
Set the "Autostart" switch to "ON".
Set the wait time with the
selection wheel under "Wait".
The wait time is the time in seconds
between the appearance of the Start
Center and the automatic start of the
project.
Value range: 0 ... 60 sec.
Note
Immediate start of the project with a delay time of 0 seconds
The project starts immediately if a delay time of
0 seconds is set. It is now no longer possible
to call the Start Center after switching on the HMI device. To handle this situation, you need
to configure an operating element with the "Close project" function.
To Next Page
Loading...
