Name: Siemens SIMATIC HMI KTP400 Basic
Brand: Siemens
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Commissioning a project

6.5 Backup and restore

Basic Panels 2nd Generation

80 Operating Instructions, 10/2016, A5E33293231-AB

6.5

Backup and restore

6.5.1

Overview

Backup and restore

You can back up and restore the following data in the internal flash memory of the HMI

device with a PC:

● Project and HMI device image

● Password list

● Recipe data

Use one of the following tools for backup and restore:

● WinCC

● ProSave

General information

Note

Power failure

If a complete restore operation is interrupted due to power failure on the HMI device, the

operating system of the HMI device may be deleted. In this case, you have to reset the HMI

device to its factor

y settings.

Compatibility conflict

If a message is output on the HMI device warning you of a compatibility conflict during the

restore operation, the operating system must be upd

ated.

Note

A data transfer can take several minutes, depending on data volume and transmission rate.

Observe the status display. Do not interrupt the data transfer.

Other manuals for Siemens SIMATIC HMI KTP400 Basic

Questions and Answers:

Need help?

Do you have a question about the Siemens SIMATIC HMI KTP400 Basic and is the answer not in the manual?

General