Commissioning the device
4.3 Parameterizing the Comfort Panel
Comfort Panels
Operating Instructions, 08/2018, A5E36770603-AC
143
3. Press "Next". The projects that are located on the external storage medium are displayed
in the following dialog. The following figure shows an example.
4. Select the project that you want to load into the HMI device. Use "Details" to receive
additional information about the selected project.
5. Press "Next". The HMI device checks whether the project data can be loaded. The result
of the check is displayed in the "Load Preview" dialog.
The following messages can be displayed in the "Load Preview" dialog:
– Alarms of type "Information":
Info
Firmware version ...
Firmware and Runtime version on the HMI device
Info Ready For Loading Project data is suitable for the HMI device
To Next Page
Loading...
