Siemens SIMATIC Ident - Page 87

Setting parameters for blocks
3.5 Programming the Ident profile
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
87
Table 3- 66 Data structure of the PUT command
Put_SET_ANT Switches the antenna of the reader off and on.
Mode RF200/RF300, MOBY U/D:
• 0x01 ≙ antenna on
• 0x02 ≙ antenna off
RF600:
• Bit 0 ≙ ANT 1 / internal antenna (1 = on)
• Bit 1 ≙ ANT 2 / external antenna (1 = on)
• Bit 4 ≙ TagList (0 = initialize, 1 = continue working with the existing list)
Length
3
Put_END Terminates communication with a transponder (MOBY U only).
UID
UID of the transponder
Mode
• 0x00 ≙ end processing of the transponder
• 0x01 ≙ processing pause of the transponder
Length
11
Table 3- 67 WRITE-ID (RF61xR/RF68xR only)
Parameter
Value / description
CMD
0x67
OFFSETBUFFER
Offset in the "TXREF" send buffer
EPCID_UID Previous EPC-ID
0x00 ≙ unspecified single tag access
LEN_ID Length of the previous EPC-ID (2-62 bytes)
0x00 ≙ unspecified single tag access
LEN_DATA
Length of the new EPC-ID
PSWD Password
0x00 ≙ no password
TXREF
New EPC-ID