Siemens SIMATIC Ident - Page 88

Setting parameters for blocks
3.5 Programming the Ident profile
Ident profile and Ident blocks, standard function for Ident systems
88 Function Manual, 10/2018, C79000-G8976-C387-04
Table 3- 68 KILL-TAG (RF61xR/RF68xR only)
Parameter
Value / description
CMD
0x6A
EPCID_UID EPC-ID
0x00 ≙ unspecified single tag access
LEN_ID Length of the previous EPC-ID (2-62 bytes)
0x00 ≙ unspecified single tag access
PSWD Password
must be ≠ 0x00
Table 3- 69 LOCK-TAG-BANK (RF61xR/RF68xR only)
Parameter
Value / description
CMD
0x79
EPCID_UID EPC-ID
0x00 ≙ unspecified single tag access
LEN_ID Length of the EPC-ID (2-62 bytes)
0x00 ≙ unspecified single tag access
PSWD Password
0x00 ≙ no password
LOCK_TAG_
BANK_ACTION
See EPC standard
LOCK_TAG_
BANK_MASK
See EPC standard
Table 3- 70 EDIT-BLACKLIST (RF61xR/RF68xR only)
Parameter
Value / description
CMD
0x7A
EDIT_BLACKLIST_MODE
• 0x00 ≙ add EPC-ID
• 0x01 ≙ Add all "Observed" transponders
• 0x02 ≙ Delete EPC-ID
• 0x03 ≙ delete all
EPCID_UID EPC-ID
0x00 ≙ unspecified single tag access
1)
LEN_ID Length of the EPC-ID (2-62 bytes)
0x00 ≙ unspecified single tag access
1)
If "EDIT_BLACKLIST_MODE" = 0x00 or 0x02 was selected, the EPC-ID including the ID length
must be specified.