Siemens SIMATIC TI555 - Finish Upgrade with These Steps

Upgrading Existing Series 500 Installations
D-5
TI545/TI555 System Manual
Series 500 Base is:
• PPX:500–5228
(16 I/O Slots) or
• PPX:500–5864
(8 I/O Slots)
Controlling Device is:
• TI530 (and IOCC if present)
• TI520 or
• PPX:500–2103 DBC
Series 500 Base is:
• PPX:500–5848
(14 I/O Slots)
• PPX:500–5884
(12 I/O Slots) or
• PPX:500–5892
(6 I/O Slots)
Controlling Device is:
• TI530C/TI530T (and IOCC if present)
• TI520C or
• PPX:500–2109 DBC
Remove controlling device: controller
(and IOCC, if present) or DBC.
1
Install PPX:500–5840 Adapter Base.
2
Upgrade Path A
1
Remove controlling device: controller
(and IOCC, if present) or DBC.
2
Set base address(es).
3
Connect twin axial cable to RBC port.
Upgrade Path B
3
Install PPX:500–2151A or
PPX:500–2153 Power Supply in slot A.
Finish upgrade with these steps:
P/S
TI555
Series 505 I/O
4, 8, or 16 slots
Local I/O
2
If power supply is in slot B, move it to
slot A. This makes I/O slot #1 available
for an I/O module.
1
Install PPX:500–51 14/A RBC.
4
Configure I/O.
TI545
or
Figur e D-1 Upgrading a TI520/TI520C/TI530/TI530C/TI530T System