Upgrading Existing Series 500 Installations
D-11
TI545/TI555 System Manual
To
install the RBC, refer to Figure D-5 and follow the steps below
.
1.
Position the RBC so that the bezel is facing you.
2.
Grasp the top and bottom of the RBC.
3.
Carefully push the RBC into the slot until it mates with the back plane
connectors.
4. T
ighten top and bottom bezel screws.
5.
Connect the RBC to the RS-485 trunkline.
Remote
Base Controller
Power Supply
Figur
e D-5
Installed
Series 500 RBC
Installing a
Series 500 RBC
To Next Page
Loading...
