Siemens SIMATIC TI555 User Manual

2-3
TI545/TI555 System Manual
Pre-installation Guidelines
2.2 Safety Considerations
Pre-installation planning and site preparation must include consideration of
hazards to personnel in the event of a system failure. The equipment
connected to the control system must include interlocks and safety switches
to help prevent operation during a system failure. Although the specific
steps depend on the application, the general precautions include the
following data.
Control devices can fail in an unsafe condition. This means that,
unless you incorporate proper safeguards, certain malfunctions of
these devices could lead to a sudden equipment startup or
shutdown. Such a startup or shutdown could result in property
damage and/or death or severe physical injury to the equipment
operator . Failure can also be exhibited as erratic or unexpected
operation.
If you, or your company , use any programmable controllers with
equipment which requires an operator or attendant, you should be
aware that this potential safety hazard exists and take appropriate
precautions. Although the specific design steps depend on your
particular application, the following precautions generally apply to
installation of solid-state programmable control devices.
These precautions conform to the guidelines for installation of
Programmable Controllers as recommended in the NEMA ICS 3–304
Programmable Control Standards.
ICS 3-304.81 Safety Recommendations:
Consideration should be given to the use of an emergency stop function which is
independent of the programmable controller.
Where the operator is exposed to the machinery, such as in loading or unloading a
machine tool, or where the machine cycles automatically, consideration should be
given to the use of an electromechanical override or other redundant means,
independent of the programmable controller, for starting and interrupting the cycle.
If provision is required for changing programs while the equipment is in operation,
consideration should be given to the use of locks or other means of assuring that such
changes can be made only by authorized personnel.
These recommendations are intended as safeguards against the failure of critical
components and the effects of such failures or the inadvertent errors that might be
introduced if programs are changed while the equipment is in operation.
The ICS 3-304.81 Safety Recommendations fr om NEMA ICS 3-304, Pr ogrammable Contr ol-
ler Standar d. Recommendations ar e r eproduced by per mission of the National Electrical
Manufactur ers Association.
WARNING
!

Siemens SIMATIC TI555 Specifications

General

Brand	Siemens
Model	SIMATIC TI555
Category	Controller
Language	English