Siemens SIMATIC TI555 - Page 137

Index-3
N
Noise
avoiding electrical, 2-8
isolating from, 2-1 1
snubbing, contact noise, 2-9
P
Power needs, planning for , 2-2
Power supply
connecting input, 4-2
series 505, 1-7
installing, 3-9
installing and removing, 3-9
power consumption, 3-9
replacing fuse, 7-12
troubleshooting, 7-12
Power-up
memory and mode status, 5-5
procedures, 6-2
Printer
connecting, 4-20
handshaking, 4-20
overview, 4-20
Program
copying into EEPROM, 5-8
editing in EEPROM, 5-10
software, 1-8
storage in EEPROM, 1-8
storage in EPROM, 1-8
R
RBC
series 500
assigning base numbers, D-12
installing and removing, D-1 1
placing in bases, D-1 1
setting baud rate, D-12
series 505
assigning base numbers, 3-19
description, 3-3
installing and removing, 3-19
installing in base, 3-19
setting baud rate, 3-16
RBE, support, 1-2
Restart
list of auxiliary functions, 7-3–7-16
using auxiliary functions, 7-2
RF to RS-485 converter , D-8
S
Safety
guidelines, 2-3
inch switch, 2-5
jog switch, 2-5
operator safety switches, 2-4
Series 500, base numbers, assigning, D-12
Series 500 RBC
installing and removing, D-1 1
LED messages, D-13
placing in bases, D-1 1
setting baud rates, D-12
Series 505
base
installing controller , 3-11–3-15
models available, 3-3
panel mounting, 3-5
models available, 3-3
rack mounting, 3-4
models available, 3-3
connecting base, 3-3
dipswitch, ports, 3-14
environmental specifications, A-2
general specifications, A-3
I/O modules, installing and removing, 3-21
installing, flowchart, 3-2
module power requirements, B-2
power supply
installing and removing, 3-9
replacing fuse, 7-12
specifications, power supply electrical, A-4
Series 505 RBC
base, installing, 3-19
base numbers, assigning, 3-19
dipswitch (factory), 3-17
installing and removing, 3-19
LED messages, 3-20