Overview
1.6 System components and accessories
IFP V2, IFP V2 PRO, IFP V2 ETH
18 Operating Instructions, 03/2023, A5E46641410-AE
Accessories can typically be used for multiple devices from the same or different device
families, for example, batteries, touch pens or protective membranes.
1.6.1 System components for IFPs
Transceiver Unit for extended versions and PRO devices
With the Transceiver Unit you can bridge a distance of up to 100 m between a PC and an
extended version or a PRO device. The Transceiver Unit is mounted close to the PC.
The Transceiver Unit can be attached on a DIN rail or in various positions on a wall using the
mounting material supplied.
① Hole for the screw to fasten the mounting
⑧ "LNK" LED
Guide for the "left" mounting rail
Connection for functional ground
Lower elongated hole of the mounting rail
X80 connector for 24 V DC power supply
X70 DisplayPort interface
Opening for "left" strain relief element
Opening for "right" strain relief element
X71 Ext-Link interface to the IFP
Guide for the "rear" mounting rail
Guide for the "right" mounting rail
Article number of the Transceiver Unit: 6AV7860-3EH00-0AA0
Scope of delivery
• A Transceiver Unit
• One mounting rail for attachment to DIN rail or wall mounting
• Strain relief elements
• One DisplayPort cable, length 0.5 m
• One USB cable Type B connector - Type A connector, length 0.5 m
• A power supply connector 24 V DC, 2-pin
To Next Page
Loading...
