Siemens SIMATIC V2 - Climatic Ambient Conditions; Long-Term Storage; Transport and Short-Term Storage; Operating Conditions

Technical information
7.4 Climatic ambient conditions
IFP V2, IFP V2 PRO, IFP V2 ETH
94 Operating Instructions, 03/2023, A5E46641410-AE
7.4 Climatic ambient conditions
7.4.1 Long-term storage
The following information applies to a device that is stored in its original packaging for longer
than two weeks.
The device meets the requirements of IEC 60721-3-1:2018 Class 1K21.
7.4.2 Transport and short-term storage
The following information applies to a device that is transported in the original packaging
and weather-proof packaging, and stored from some time.
The device was tested according to IEC 60721-3-2:2018 Class 2K11 with the following
amendments and limitations:
Type of condition
Permitted range
Temperature
–20 ... 60 °C
Atmospheric pressure
1140 ... 660 hPa, corresponds to an elevation of -1000 to 3500 m
Relative humidity
10 ... 90 %
Pollutant concentration
According to ANSI/ISA-71.04-2013 severity level G3
Note
If dewing has developed, wait until the device has dried completely before switching it on.
Do not expose it to direct heat radiation from a heating device.
7.4.3 Operating Conditions
The following information applies to a device installed according to the specifications in these
operating instructions.
The device is designed for weatherproof and stationary operation according to
IEC 60721-3-3.
The device was tested according to IEC 60721-3-3:2019 Class 3K3 with the following
amendments and limitations:
Type of condition
Mounting position
Permitted range
Temperature built-in de-
vices,
Mounting in landscape
format
Vertical
0 ... 50 °C (12", 15" and 19" device)
0 ... 45 °C (22" and 24" device)
Inclined, maximum inclination
35°
0 ... 40 °C