Siemens SIMATIC V2 - Transceiver Unit; Permitted Mounting Positions

Installing and connecting the device
3.1 Preparing for installation
IFP V2, IFP V2 PRO, IFP V2 ETH
40 Operating Instructions, 03/2023, A5E46641410-AE
PRO devices for support arm (extendable, round tube)
Devices with landscape format display
Devices with portrait format display
Note
Mounting positions other than the standard mounting positions illustrated are
not permitted
for the PRO devices.
3.1.4 Transceiver Unit
3.1.4.1 Permitted mounting positions
The following mounting positions are permitted for the Transceiver Unit:
Mounting on the rear
Mounting on one side
The Transceiver Unit can be mounted on a DIN rail or on a wall using screws.
The interfaces of the Transceiver Unit should always point downwards.