IFP V2, IFP V2 PRO, IFP V2 ETH
84 Operating Instructions, 03/2023, A5E46641410-AE
Technical information
7.1 Certificates and approvals
Approvals on the rating plate
The following overview shows possible approvals.
Only the approvals specified on the rating plate apply to the device.
See also
Rating plate (Page 123)
CE marking
The devices meet the general and safety-related requirements of the following EU directives
and conform to the harmonized European standards (EN) for these devices published in the
official gazettes of the European Community and confirmed in the EU Declarations of
Conformity:
• 2014/35/EU "Electrical equipment designed for use within certain voltage limits" (Low
Voltage Directive)
• 2014/30/EU "Electromagnetic Compatibility Directive" (EMC Directive)
• 2011/65/EU "Directive of the European Parliament and of the Council of 8 June 2011 on
the restriction of the use of certain hazardous substances in electrical and electronic
equipment" (RoHS Directive)
• ErP Directive (EU) 2019/2021 "Commission Regulation laying down ecodesign
requirements for electronic displays pursuant to Directive 2009/125/EC of the European
Parliament and of the Council, amending Commission Regulation (EC) No 1275/2008 and
repealing Commission Regulation (EC) No 642/2009"
When the device has Ex approval, the following also applies:
• 2014/34/EU "Equipment and protective systems for use in hazardous areas" (Explosion
protection directive)
EU Declarations of Conformity
The EU Declarations of Conformity are available to the relevant authorities at the following
address:
Siemens AG
Digital Industries
Factory Automation
DI FA TI COS
To Next Page
Loading...
