Siemens SIMATIC V2 - Page 27

Safety instructions
2.1 General safety instructions
IFP V2, IFP V2 PRO, IFP V2 ETH
Operating Instructions, 03/2023, A5E46641410-AE
27
Additional information for the Transceiver Unit
WARNING
The device constitutes open equipment
The device is open equipment. This means that the device may only be integrated in an
enclosure or cabinet.
The enclosure or the cabinet must provide protection against electric shock and the spread
of fire. The enclosure or the cabinet must meet the requirements for mechanical strength
and the degree of protection for the relevant application.
Access to the enclosure or cabinet in which the device is installed should only be possible by
means of a key or tool and for trained and qualified personnel.
Electrocution risk when control cabinet is open
When you open the control cabinet, there may be a dangerous voltage at certain areas or
components.
If you touch these areas or components, you may be killed by electric shock.
Disconnect the cabinet from the mains before opening it. Do not plug in or pull out plant
components during operation.
Safety on the plant or system
NOTICE
The plant operator is responsible for the safety
The installer of the plant or system is responsible for the safety of the plant or system in
which the device is integrated.
ESD
An electrostatically sensitive device is equipped with electronic components. Due to their
design, electronic components are sensitive to overvoltage and thus to the discharge of static
electricity. Observe the corresponding regulations when handling ESD.
Industrial Security
Siemens provides products and solutions with industrial security functions that support the
secure operation of plants, systems, machines and networks.
In order to protect plants, systems, machines and networks against cyber threats, it is
necessary to implement – and continuously maintain – a holistic, state-of-the-art industrial
security concept. Siemens’ products and solutions constitute one element of such a concept.
Customers are responsible for preventing unauthorized access to their plants, systems,
machines and networks. Such systems, machines and components should only be connected