SINUMERIK
®
documentation
Printing history
Brief details of this edition and previous editions are listed below.
The status of each edition is shown by the code in the ”Remarks” column.
Status code in ”Remarks” column:
A . . . New documentation.
B . . . Unrevised reprint with new Order No.
C . . . Revised edition with new status.
If factual changes have been made on the page since the last edition, this is
indicated by a new edition coding in the header on that page.
Edition Order No. Remarks
11.92 6FC5197-0AA60-1BP0 A
06.93 6FC5197-2AA60-0BP0 C
12.93 6FC5197-3AA60-0BP0 C
10.94 6FC5197-4AA60-0BP0 C
03.95 6FC5197-4AA60-0BP1 C
09.95 6FC5197-5AA60-0BP0 C
04.96 6FC5197-5AA60-0BP1 C
08.96 6FC5197-5AA60-0BP2 C
07.97 6FC5197-6AA60-0BP0 C
01.99 6FC5197-6AA60-0BP1 C
09.01 6FC5197-6AA60-0BP2 C
Other functions not described in this documentation might be
executable in the control. This does not, however, represent an
obligation to supply such functions with a new control or when
servicing.
We have checked that the contents of this publication agree with
the hardware and software described herein. The information given
in this publication is reviewed at regular intervals and any
corrections that might be necessary are made in the subsequent
printings. Suggestions for improvement are welcome at all times.
Subject to change without prior notice.
Siemens-Aktiengesellschaft
For more information, refer to the Internet:
http://www.ad.siemens.de/sinumerik
The publication was produced on the Siemens 5800 Office System.
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including created by
patent grant or registration of a utility model or design, are reserved,
© Siemens AG 1992-2001
All Rights Reserved
Order No. 6FC5197-6AA60-0BP2
Printed in the Federal Republic of Germany
This manual is included in the documentation on CD-ROM (DOCONCD)
Edition Order No. Remarks
10.01 6FC5198-6CA00-0BG2 C
Trademarks
SIMATIC®, SIMATIC HMI®, SIMATIC NET®, SIROTEC®, SINUMERIK® and SIMODRIVE® are trade-
marks of Siemens AG. All other product and system names are registered trademarks of their
respective companies and must be treated accordingly.
To Next Page
Loading...
Need help?
General
