Siemens SIMOTION D45 Series - Operator Control Elements; Mode Selector

Operator control (hardware)
2.2 Operator control elements
D4x5
26 Manual, 03/2007 Edition
2.2 Operator control elements
2.2.1 Mode selector
Properties of the mode selector
SIMOTION D4x5 unit has a mode selector in the lower section of the front panel.
The right switch labeled PLC is used for switching the operating mode of the
SIMOTION D4x5.
The left service switch (labeled SIM/NCK) is only relevant for service technicians and must
always be kept at position 0 (see figure below).
0RGHVHOHFWRU6HUYLFHVZLWFK
Figure 2-2 SIMOTION D4x5 mode selector
Caution
Always use an insulated screwdriver to activate the mode selector. Otherwise, static
electricity can destroy the switch.
Note
It is recommended that SIMOTION SCOUT be used exclusively to switch the operating
modes of the module. Therefore, leave the mode selector at position 0 (RUN). The LED
display indicates the current mode selection.
For information on how to set the operating mode using SIMOTION SCOUT, refer to the
SIMOTION SCOUT Configuring Manual.