Interfaces
3.6 PROFIBUS DP interfaces X126 and X136
D4x5
46 Manual, 03/2007 Edition
Position of connectors
The following figure shows the mounting position and designation of the connectors on the
control unit.
'303,
;
;
'3
Figure 3-6 Position of connectors X126, X136
Connectable devices
The following devices can be connected to the PROFIBUS DP interfaces:
• Programming devices/PCs
• SIMATIC HMI devices
• SIMATIC S7 controllers with PROFIBUS DP interface
• Distributed I/O
• Teleservice adapter
• Drive units with PROFIBUS DP interface (standard slaves)
Note
A teleservice adapter can only be connected to one of the two interfaces.
All approved modules and devices are listed in the
PM 10
SIMOTION Catalog (for order
number, see list of references).
Take note of the documentation on the individual modules or devices!
To Next Page
Loading...
