Functions
6.9 Technological functions
SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
153
Table 6- 50 Parameters for switching the drive data sets:
P0820 = …
1st control command for switching the drive data sets
Example: When P0820 = 722.0, the system switches from drive data set 0 to drive
data set 1 via digital input 0
P0821 = …
2nd control command for switching the drive data sets
Displaying the number of the DDS that is currently active
A copy function is available making it easier to commission more than one drive data set:
Number of the drive data set to be copied (source)
Number of the drive data to which the data is to be copied (target)
For an overview of all the parameters that belong to the drive data sets and can be switched,
see the List Manual.
To Next Page
Loading...
