Commissioning
5.6 Commissioning with STARTER
SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
69
Commissioning with STARTER
Basic commissioning
The STARTER software uses a series of dialogs to guide the user through the basic
commissioning of the Inverter. For specific application configuration and parameterization
the expert list within STARTER should be used.
Note
STARTER knowledge
This procedure assumes that you have a working knowledge of the STARTER software.
The following items are required to commission the Inverter with STARTER:
● The PC connection cable - order number: 3RK1922-2BP00 or the USB connection cable -
order number: 6SL3555-0PA00-2AA0.
● STARTER software installed on your PC - order number: 6SL3072-0AA0-0AG0 (the
version of STARTER should be version 4.1 Service Pack 3 or higher.
Note
PC connection cable 3RK1922-2BP00
Version E02 or higher of the PC connection cable should be used with the SINAMICS
G110D/G120D Inverter.
To Next Page
Loading...
