Siemens SINAMICS G110D - Commissioning; Typical commissioning scenarios

SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
61
Commissioning
5
5.1
Typical commissioning scenarios
Alternative commissioning options
The functions of the Inverter are activated and configured using parameters. Parameters can
either be accessed from the operator control/display instrument (Operator Panel) or using
the STARTER software from the PC using the appropriate Inverter interface.
Parameter information and data can also be accessed and modified over the AS-interface.
For further details please see the section "Operation in fieldbus system".
Inverters can also be parameterized by saving the valid Inverter parameter set on an SD
memory card then transferring it to a different Inverter with the same configuration and
function.
The commissioning scenarios listed below are described in the following sections:
● Commissioning, using the factory settings
● Commissioning with the STARTER software
● Commissioning using the Operator Panel
● Data backup with the SD memory card