Functions
6.11 Operation in fieldbus systems
SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
165
Automatic address programming is set by default, i.e. if a slave is replaced due to a fault, the
slave that replaces it will be automatically assigned the previous slaves address. If this
action is not required it can be deselected.
Image 6-28 Properties dialog CP343-2 - operating parameters
Note
Configuration overwritten
A configuration of the AS
-i slaves set by STEP 7 and downloaded to the S7 station is
transferred from the CPU to the CP343
-2 when the S7 station starts up. Any configuration
buttons is then overwritten.
To configure a specific slave configuration, select the "Slave Configuration" tab.
Double-click on the row in the displayed table in which you want to enter an AS-i slave with
the corresponding address; this opens the properties dialog for AS-i slaves.
To Next Page
Loading...
