Connection
4.9 Configuring the AS-i slave
SINAMICS G110D
54 Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
Prior to the installation and commissioning of the Inverter, the AS-i communications and
devices have to be set-up correctly. The equipment shown in the table below will be
necessary for the successful integration of more than one Inverter onto the AS-i bus network.
Table 4- 20 Equipment for installation of SINAMICS G110D (AS-i)
Address cable 3RK1901-3HA01
AS-i address programmer 3RK1904-2AB01
AS-i connection kit 3RK1901-1NR21
To Next Page
Loading...
