Siemens SINAMICS G120 - Setting SS1 with Acceleration Monitoring

5.12.5.2 Setting SS1 with acceleration monitoring
Requirement
You are online with STARTER or Startdrive.
Procedure with STARTER
To set the SS1 function with acceleration monitoring, proceed as follows:
1. Select "[3] Safety without encoder with accel_monitoring (SAM)/delay time".
2. Press the "Safe stop functions" button.






3. After the "delay time", the inverter safely switches off the motor torque – regardless of the
actual speed.
4. The "shutdown speed SS1" is a condition for the transition into the STO function.
5. The "speed tolerance" is used to track the monitoring to the actual speed.
6. The "shutdown speed acceleration monitoring" is a condition for the transition into the STO
function.
7. Close the screen form.
You have set the SS1 function with acceleration monitoring.


Commissioning
5.12 Setting extended functions
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
180 Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD