Siemens SINAMICS G120D - Guide through this Manual

Introduction
2.2 Guide through this manual
Converter with control units CU250D-2
22 Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
2.2
Guide through this manual
①
Inverter components and accessories.
Permissible motors.
Tools for commissioning.
②
Install and wire the inverter and its components.
Install the inverter in accordance with EMC.
③
Prepare for commissioning.
Restore the inverter to factory settings.
Define the inverter’s basic settings.
④
Adjust the fu
nction of the inputs and outputs.
⑤
Configure communication via PROFIBUS or PROFINET.
Communication using other fieldbuses can be found in the
"Fieldbus" function manual; see also:
Manuals and technical
support (Page 387).
⑥
Set up the functions, e.g. setpoint processing, motor control
and protection functions.
⑦
Backup the inverter’s settings to an external data storage
medium, e.g. a memory
card or an operator panel.
⑧
Replace the inverter and its components.
Firmware update.
⑨
Meaning of the LEDs on the front of the inverter.
System runtime.
Faults and warnings.
⑩
The most important technical data of the inverte
r.
⑪
Setting up the new inverter functions.
Application examples.