Installation
4.2 Electrical Installation
Converter with control units CU250D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
51
Factory settings of the inputs and outputs
Factory settings of the inputs and outputs of the CU250D-2 control unit
In the factory settings, the fieldbus interface of the inverter is not active.
Figure 4-15 Factory settings of the CU250D-2 control units
Changing the function of the inputs and outputs
The function of each color-identified input and output can be set.
To avoid having to change each input individually, you can set multiple inputs and outputs
together using default settings.
The factory setting of the inputs and outputs described above corresponds to the default
setting 7 (switchover between fieldbus and a jog using DI 3).
See also: Default settings of inputs and outputs (Page 52).
To Next Page
Loading...
