Siemens SINAMICS G120D - Backing up and Transferring Settings Using STARTER

Backing up data and series commissioning
8.2 Backing up and transferring settings using STARTER
Converter with control units CU250D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
281
8.2
Backing up and transferring settings using STARTER
With the supply voltage switched on,
you can transfer the converter settings
from the converter to a PG/PC, or the
data from a PG/PC to the converter.
The precondition is that you have a
commissioning tool on your PG/PC.
You will find more information on PC tools in section: Commissioning tools (Page 25).
Inverter
→
PC/PG
Procedure with STARTER
To back up the settings with STARTER, proceed as follows:
1. Go online:
.
2. Click the "Download project to PG" button:
.
3. Save the project:
.
4. Wait until STARTER reports that data backup has been completed.
5. Go offline:
.
You have backed up the settings with STARTER.
Procedure with Startdrive
To back up the settings with Startdrive, proceed as follows:
1. Go online.
2. Select "Online" > "Upload device to PG/PC."
3. Back up the project with "Project" > "Save."
4. Wait until Startdrive reports that data backup has been completed.
5. Go offline.
You have backed up the settings with Startdrive.