Siemens SINAMICS G120D - Standards (PM250 D)

Technical data
11.8 Standards (PM250D)
Converter with control units CU250D-2
352 Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
11.8
Standards (PM250D)
European Low Voltage Directive
The SINAMICS G120D-2 product range complies with the requirements of the Low Voltage Directive
2006/95/EC. The units are certified for complaince with the following standards:
EN 61800-5-1 — Semiconductor inverters –General requirements and line commutated inverters
EN 60204-1 — Safety of machinery –Electrical equipment of machines
European Machinery Directive
The SINAMICS G120D-2 inverter series does not fall under the scope of the Machinery Directive.
However, the products have been fully evaluated for compliance with the essential Health & Safety
requirements of the directive when used
in a typical machine application. A Declaration of Incorporation
is available on request.
European EMC Directive
When installed according to the recommendations described in this manual, the SINAMICS G120D-2
fulfils all requirements of the EMC Directive as defined by the EMC Product Standard for Power Drive
Systems EN 61800-3
Underwriters Laboratories
UL and CUL LISTED POWER CONVERSION EQUIPMENT for use in a pollution degree 2 environ-
ment.
SEMI F47
Specification for Semiconductor Process Equipment Voltage Sag Immunity
SINAMICS G120D-2 Inverters fulfill the requirements of the SEMI F47-0706 standard.
ISO 9001
Siemens plc operates a quality management system, which complies with the requirements of
ISO 9001.
Certificates can be downloaded from the internet under the following link:
Standards (http://support.automation.siemens.com/WW/view/en/22339653/134200)