Commissioning
5.4 Basic commissioning with a PC
Converter with control units CU250D-2
72 Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
Setting the USB interface in STARTER
Procedure
Proceed as follows to set the USB interface in STARTER:
1. Set the "Access point" to "DEVICE (STARTER, Scout)" and the "PG/PC interface" to
"S7USB".
2. Press the "Update" button.
You have set the USB interface.
STARTER now shows the inverters connected via USB.
To Next Page
Loading...
