Siemens SINAMICS S 1PH7 - Table of Contents

1PH7 induction motors (Machine tools)
Configuration Manual, (APH7W), 04/2009, 6SN1197-0AD72-0BP0
13
Table of contents
Preface ...................................................................................................................................................... 5
1 Motor description ..................................................................................................................................... 17
1.1 Properties.....................................................................................................................................17
1.1.1 Torque overview ..........................................................................................................................18
1.2 Technical features........................................................................................................................19
1.3 Selection and ordering data.........................................................................................................22
1.4 Rating plate data..........................................................................................................................36
2 Configuration ........................................................................................................................................... 39
2.1 Configuring software....................................................................................................................39
2.1.1 SIZER engineering tool................................................................................................................39
2.1.2 STARTER drive/commissioning software....................................................................................41
2.1.3 SinuCom commissioning tool.......................................................................................................41
2.2 SINAMICS procedure when engineering.....................................................................................42
2.3 Selecting and dimensioning induction motors .............................................................................43
2.3.1 Clarification of the type of drive....................................................................................................43
2.3.2 Defining the supplementary conditions and integration into an automation system....................43
2.3.3 Selecting induction motors...........................................................................................................44
2.3.4 Motor operates continuously........................................................................................................44
2.3.5 Motor operates with a periodic duty cycle....................................................................................45
2.3.6 A high field weakening range is required.....................................................................................46
3 Mechanical properties of the motors........................................................................................................ 49
3.1 Cooling.........................................................................................................................................49
3.2 Degree of protection acc. to EN 60034-5 ....................................................................................52
3.3 Bearing version ............................................................................................................................53
3.3.1 Drive output types and bearing versions .....................................................................................53
3.3.2 Bearing lifetime ............................................................................................................................55
3.4 Radial and axial forces...................................................................................................
..............59
3.4.1 Radial force (cantilever force)......................................................................................................59
3.4.2 Radial force diagrams ..................................................................................................................61
3.4.3 Axial force ....................................................................................................................................73
3.4.4 Axial force diagrams ....................................................................................................................74
3.5 Shaft end and balancing ..............................................................................................................79
3.6 Radial eccentricity, concentricity and axial eccentricity...............................................................80
3.7 Balancing process........................................................................................................................81
3.8 Vibration severity level .................................................................................................................83
3.9 Paint finish....................................................................................................................................84