Siemens SINAMICS S120 - Trace Function

Diagnosis
Diagnostics using STARTER
6-207
E Siemens AG, 2004. All rights reserved
SINAMICS S120 Installation and Start-Up Manual, 12/04 Edition
6.2.2 Trace function
Description
The trace function can be used to record measured values over a defined period
depending on trigger conditions.
Note
The following tool is available for using the trace function and plotting the recorded
measurements:
STARTER parameterization and commissioning tool ––> see Section 3.2
For further information about the trace function, see Section 6.2 and online help.
Parameterizing and using the trace function
The parameterization and commissioning tool STARTER (see Section 3.2) will help
you parameterize and use the trace function properly.
Fig. 6-6 “Trace function” initial screen