Commissioning
Initial commissioning using vector (chassis) as an example
3-67
E Siemens AG, 2004. All rights reserved
SINAMICS S120 Installation and Start-Up Manual, 12/04 Edition
3.6.1 Task
1. Commission a drive system with the following components:
Table 3-8 Component overview
Designation
Component Order number
Closed-loop control and infeed
Control Unit Control Unit 320 6SL3040-0MA00-0AAx
Active Line Module Active Line Module
380 kW / 400 V
6SL3330-7TE36-1AAx
Active Interface
Module
Active Interface Module 6SL3300-7TE38-4AAx
Drive 1
Motor Module Motor Module 380 A 6SL3320-1TE33-8AAx
Motor Induction motor
– without brake
– with encoder
Type: 1LA8
Rated voltage = 400 V
Rated current = 345 A
Rated output = 200 kW
Rated power factor = 0.86
Rated frequency = 50.00 Hz
Rated speed = 989 1/min
Cooling method = self cooling
HTL encoder, 1024 p/r, A/B, R
Drive 2
Motor Module Motor Module 380 A 6SL3320–1TE33–8AAx
Motor Induction motor
– without brake
– with encoder
Type: 1LA8
Rated voltage = 400 V
Rated current = 345 A
Rated output = 200 kW
Rated power factor = 0.86
Rated frequency = 50.00 Hz
Rated speed = 989 1/min
Cooling method = self cooling
HTL encoder, 1024 p/r, A/B, R
2. The enable signals for the infeed and drive are to be transmitted via terminals.
To Next Page
Loading...
