Preface
ix
E Siemens AG, 2004. All rights reserved
SINAMICS S120 Installation and Start-Up Manual, 12/04 Edition
Technical notes
Technical support
If you have any further questions, please call our hotline:
A&D Technical Supports Tel.: +49 (0) 180 5050 - 222
Fax: +49 (0) 180 5050 - 223
http://www.siemens.com/automation/support-request
Please send any questions about the documentation (suggestions for improve-
ment, corrections, and so on) to the following fax number or email address:
+49 (0) 9131 98 - 2176
Fax form: see feedback page at the end of this documentation
Email: motioncontrol.docu@erlf.siemens.de
Internet address
Up-to-date information about our products can be found on the Internet at the follo-
wing address:
http://www.ad.siemens.com/drives
Notation
The following notation and abbreviations are used in this documentation:
Notation for parameters (examples):
S p0918 Adjustable parameter 918
S r1024 Visualization parameter 1024
S p1070[1] Adjustable parameter 1070, index 1
S p0099[0...3] Adjustable parameter 99, indices 0 to 3
S r0945[2](3) Visualization parameter 945, index 2 of drive object 3
S p0795.4 Adjustable parameter 795, bit 4
Notation for faults and alarms (examples):
S F1234 Fault 1234
S A5678 Alarm 5678
General notation:
S The sign “” means “is equal to”
To Next Page
Loading...
