EasyManuals Logo

Siemens SINUMERIK 840D sl Manual

Siemens SINUMERIK 840D sl
265 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
Safety Integrated
4.2 SINUMERIK Safety Integrated
Guide for the SINUMERIK 840D sl machine configuring
Manual, 07/2006 Edition, 6FC5397-6CP10-0BA0
4-11
Protective door interlocked state [F-DI terminal 5 (channel 1), terminal 13 (channel 5)]
The door switch only interlocks if the actuator is inserted. The contacts of the monitoring
circuit then signal the status "closed and interlocked"
Signal state channel 1 = "1" and channel 5 = "1":
Protective door closed and interlocked.
Signal state channel 1 = "0" and channel 5 = "0":
Protective door not closed or not interlocked.
Agreement button [F-DI terminal 3 (channel 2), terminal 11 (channel 6)]
Signal state channel 2 = "1" and channel 6 = "0":
Agreement button pressed.
Signal state channel 2 = "0" and channel 6 = "1":
Agreement button not pressed.
Drives On button [F-DI terminal 7 (channel 3), terminal 15 (channel 7)]
Signal state channel 3 = "0" and channel 7 = "0":
Drives On button not pressed.
Signal state channel 3 = "1" and channel 7 = "1":
Drives On button pressed.
VS1: internal sensor supply for channel 0 to 3
VS2: internal sensor supply for channel 4 to 7
These two sensor supplies must be used when the short-circuit test is activated. The
exclusive OR sensor agreement button is an exception. For this sensor variant, in
conjunction with the short-circuit test, the VS1 sensor supply must be used for both contacts.

Table of Contents

Other manuals for Siemens SINUMERIK 840D sl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D sl and is the answer not in the manual?

Siemens SINUMERIK 840D sl Specifications

General IconGeneral
Control TypeCNC
Number of AxesUp to 31
Max Number of Channels10
InterfacesEthernet, PROFIBUS, PROFINET, USB
Interpolation5-axis interpolation
Operating Temperature0°C to 45°C
Relative HumidityUp to 95% (non-condensing)
DisplayTFT color display, various sizes
Programming LanguagesDIN/ISO
Safety FeaturesSafety Integrated
PLCIntegrated PLC S7-300
Drive InterfaceSINAMICS S120
Data StorageCF card, USB
Operating SystemWindows-based

Related product manuals