Siemens SINUMERIK 840D sl - 4.3 Operating modes

Connection of the Components
5.2 Line Contactor Control
Guide for the SINUMERIK 840D sl machine configuring
Manual, 07/2006 Edition, 6FC5397-6CP10-0BA0
5-9
L1
L2
L3
6PDUW/LQH0RGXOHN:
3/&
',
3/&
'2
3/&
'2
3/&
',
3/&
',
8 9  


;:
;
(3
0
(3
9
0
5HDG\ 3UH:DUQLQJ 5HVHW
/
0
6DIHW\
FRQWURO
3XOVHHQDEOH
Figure 5-7 Line Contactor Control for Smart Line Module without DRIVE-CLiQ
Note
If the line contactor should also be safely disconnected (safety), the control must be
integrated in an existing safety control. This is required so that the line contactor is
switched in accordance with the required safety categories; also refer to the "Safety
Integrated" section.