Motion commands
4.10 Circular interpolation with intermediate and end points (CIP)
Fundamentals
146 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Note
CIP is modal.
Input in absolute and incremental dimensions
The G90/G91 defaults for absolute or incremental dimensions are valid for the intermediate
and circle end points.
With G91, the circle starting point is used as the reference for the intermediate point and end
point.
Example of milling
;
=
<
<
In order to machine an inclined circular groove, a circle is described by specifying the
intermediate point with 3 interpolation parameters, and the end point with 3 coordinates.
N10 G0 G90 X130 Y60 S800 M3
;Approach starting point
N20 G17 G1 Z-2 F100
;Tool infeed
N30 CIP X80 Y120 Z-10
;Circle end point and intermediate point:
I1= IC(-85.35)J1=IC(-35.35) K1=-6
;Coordinates for all three geometry axes
N40 M30
;End of program
To Next Page
Loading...
