Feedrate Control and Spindle Motion
7.1 Feedrate (G93, G94, G95 or F..., FGROUP, FGREF)
Fundamentals
270 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Note
The inverse-time feedrate 1/min G93 is not implemented for 802D.
Programming
G93 or G94 or G95
F…
or
FGROUP (X, Y, Z, A, B, …)
Or
FL[axis]=…
or
FGREF[axis name]=reference radius
Parameters
G93
Inverse-time feedrate 1/rpm
G94
Feedrate in mm/min or inches/min or in deg/min
G95
Feedrate in mm/rev or inches/rev with reference to the speed of the master
spindle – generally the cutting spindle or the main spindle on the turning
machine
F…
Feedrate value in unit defined by G93, G94, G95
FGROUP
Feedrate value F valid for all axes specified in FGROUP
FL
Limit speed for synchronized/path axes; the unit set with G94 applies
(max. rapid traverse) One FL value can be programmed per axis. The axis
identifiers of the basic coordinate system must be used (channel axes or
geometry axes).
FGREF
Effective radius (reference radius) for the rotary axes entered in FGROUP
Axis
Channel axis or geometry axes or orientation axes
X Y Z
Movement of the specified geometry axis
A B C
Axis identifier for rotary axis to be traversed
To Next Page
Loading...
