Motion commands
4.15 Thread cutting with constant lead (G33)
Fundamentals
164 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
4.15 Thread cutting with constant lead (G33)
Function
With G33 three types of thread
• Cylinder thread
• Face thread
• Taper thread
can be produced with single or multiple threads as right-hand or left-hand thread.
Thread chains
By programming several G33 blocks consecutively, you can align several sets of threads in a
sequence. With G64 continuous-path mode, the blocks are interconnected in a look ahead
velocity control so that no speed jumps are produced.
To Next Page
Loading...
