Positional Data
3.4 Dimensions inch/metric, (G70/G700, G71/G710)
Fundamentals
88 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
You can also use DC, ACP and ACN for spindle positioning from zero speed.
Example: SPOS=DC(45)
3.4 Dimensions inch/metric, (G70/G700, G71/G710)
Function
Depending on the dimensions in the production drawing, you can program workpiece
geometries alternately in metric measurements and inches.
Programming
Call-up
G70 or G71
G700 or G710
Parameters
G70
Imperial measure (length [inches])
G71
Metric dimensions (length [mm])
G700
Imperial measure (length [inch]; feedrate [inch/min])
G710
Metric dimensions (length [mm]; feedrate F [mm/min])
G700/G710
The functionality of G70/G71 has been extended with G700/G710. In addition to the
geometrical parameters, the technological parameters, such as feed F, are interpreted
during parts program execution in the measuring system set in G700/G710.
The controller interprets all feedrates used with G700/G710 in the programmed measuring
system, unlike G70/G71.
The programmed feedrate value is modal and thus does not change automatically on
subsequent G70/G71/G700/G710 selections.
To Next Page
Loading...
