Siemens SINUMERIK 840Di sl - List of G Functions;Preparatory Functions

Tables
12.3 List of G functions/preparatory functions
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
479
OEM addresses
OMA1: OEM
address 1
2
)
OEM
address 1
m x x x 1 Real
OMA2: OEM
address 2
2
)
OEM
address 2
m x x x 1 Real
OMA3: OEM
address 3
2
)
OEM
address 3
m x x x 1 Real
OMA4: OEM
address 4
2
)
OEM
address 4
m x x x 1 Real
OMA5: OEM
address 5
2
)
OEM
address 5
m x x x 1 Real
*) Absolute end points: modal, incremental end points: non-modal, otherwise modal/non-
modal depending on syntax of G function.
**)As circle center points, IPO parameters act incrementally. They can be programmed in
absolute mode with AC. The address modification is ignored when the parameters have
other meanings (e.g., thread pitch).
1
) The vocabulary word is not valid for SINUMERIK FM-NC/810D.
2
) The vocabulary word is not valid for SINUMERIK FM-NC/810D/NCU571.
12.3 List of G functions/preparatory functions
List of G functions/preparatory functions
In the list of G functions/motion commands you will find all available G codes according to
the appropriate functional groups.
Legend for describing the G groups
No.: internal number for, e.g., PLC interface
X: No. for GCODE_RESET_VALUES not permitted
m: modal or n: non-modal
Def.: Siemens AG (SAG) default setting, M: Milling: T: Turning or other conventions
MM.: Default setting, please see machine manufacturer's instructions
Group 1: Modally valid motion commands
Name No. Meaning X m/n SAG MM
G0 1. Rapid traverse m
G1 2. Linear interpolation (linear interpolation) m Def.
G2 3. Circular interpolation clockwise m
G3 4. Circular interpolation counter-clockwise m
CIP 5. Circle through points: Circular interpolation through intermediate point m
ASPLINE 6. Akima spline m
BSPLINE 7. B-spline m
CSPLINE 8. Cubic spline m