Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
431
Tables
12
12.1 List of statements
Legend:
1
Default setting at beginning of program (factory settings of the control, if nothing else programmed)
2
The groups are numbered according to the table in section "List of G functions/preparatory functions".
3
Absolute end points: modal (m);
incremental end points: non-modal (n);
otherwise: modal/non-modal depending on syntax of G function
4
As circle center points, IPO parameters act incrementally. They can be programmed in absolute mode with AC. The
address modification is ignored when the parameters have other meanings (e.g., thread pitch).
5
The keyword is not valid for SINUMERIK 810D.
5
The keyword is not valid for SINUMERIK 810D/NCU571.
7
The keyword is not valid for SINUMERIK FM-NC.
8
The OEM can add two extra interpolation types. The names can be changed by the OEM.
9
Extended address notation cannot be used for these functions.
Name Meaning Value Description,
comment
Syntax m/s
3
Group
2
: Block number - main
block (see N)
0 ...
99 999 999
integers only,
without signs
Special
identification of
blocks, instead
of N... ;this
block should
contain all
statements
required for a
complete
subsequent
machining
section.
e.g.,20
A Axis Real m/n
A2
5
Tool orientation: Euler
angles
Real s
To Next Page
Loading...
