Siemens SINUMERIK 840Di sl - 5.6 Zero;work offset

Frames
6.2 Frame instructions
Fundamentals
230 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Programming
TRANS X… Y… Z… or ATRANS X… Y… Z… or
G58 X… Y… Z… A… or G59 X… Y… Z… A… or
ROT X… Y… Z… or ROT RPL=… or AROTX… Y… Z… or AROT RPL=… or
ROTS X... Y... or AROTS X... Y... or CROTS X... Y... or
SCALE X… Y… Z… or ASCALE X… Y… Z… or
MIRROR X0 Y0 Z0 or AMIRROR X0 Y0 Z0 or
TOFRAME or TOFRAMEZ or TOFRAMEY or TOFRAMEX or
TOROTOF or TOROT or TOROTZ or TOROTY or TOROTX or
PAROT or PAROTOF or
CORROF(axis,string[axis,string]) or CORROF(axis,string) or
CORROF(axis) or CORROF()
Caution
The above frame instructions are programmed in separate NC blocks and executed in the
programmed order.
TRANS, ROT, SCALE and MIRROR instructions.
Substituting instructions
TRANS, ROT, SCALE and MIRROR are substituting instructions.
75$16$75$16
6&$/($6&$/( 0,5525$0,5525
527
$527
<
;
<
;
<
;
<
;