Tool offsets
8.15 Grinding-specific tool monitoring in parts programs (TMON, TMOF)
Fundamentals
392 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Note
When transferring angular values to a standard or measuring cycle, the following should be
carefully observed:
Values less than the calculation resolution of the NC should be rounded-off to zero!
The calculation resolution of the NC for angular positions is defined in the machine data:
MD10210 $MN_INT_INCR_PER_DEG
8.15 Grinding-specific tool monitoring in parts programs (TMON, TMOF)
Function
The command TMON is used to activate geometry and speed monitoring for grinding tools
(types 400-499) in the NC parts program. Monitoring remains active until it is deactivated in
the parts program with TMOF.
Machine manufacturer
See machine manufacturer's specifications
Programming
TMON (T no.)
Or
TMOF (T no.)
To Next Page
Loading...
