Siemens SINUMERIK 840Di sl - Two Straight Lines (ANG1, X3

Motion commands
4.14 Contour definitions
Fundamentals
160 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Example
N10 X5 Z70 F1000 G18
;Approach start position
N20 X88.8 ANG=110 or (Z39.5 ANG=110)
;Straight line with specified angle
N30 ...
4.14.2 Two straight lines (ANG1, X3... Z3... ANG2)
Function
The intersection of the two straight lines can be designed as a corner, curve or chamfer. The
end point of the first of the two straight lines can be programmed by defining the coordinates
or specifying the angle.
$1*
;
=
;=
;=
$1*
;=
$1*
;
=
;=
;=
$1*
;=
&DQDOVREHUDGLXV&DQDOVREHUDGLXV
RUFKDPIHU
RU&+5RU&+5
Programming
ANG1…
X3… Z3… ANG2…
Or
X1… Z1…
X3… Z3…