Frames
6.3 Programmable zero offset
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
233
Turning:
;
=
0
:
*
75$16
Deactivate programmable zero offset:
For all axes: TRANS (without axis parameter)
Programming
TRANS X… Y… Z… (substituting instruction programmed in a separate NC block)
Or
ATRANS X… Y… Z… (additive instruction programmed in a separate NC block)
Parameters
TRANS
Absolute zero offset, with reference to the currently valid workpiece zero
set with G54 to G599
ATRANS
as TRANS, but with additive zero offset
X Y Z
Offset value in the direction of the specified geometry axis
To Next Page
Loading...
