Tool offsets
8.5 Tool selection T with tool management
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
339
8.5.1 Turning machine with circular magazine (T selection)
Function
The tools must be assigned unique names and numbers for identification purposes. Below it
will be demonstrated how to uniquely define the parameters for the tool management option
on a turning machine with circular magazine.
Machine manufacturer
Tool management: See machine manufacturer's configuration.
Programming
The following sequence usually applies:
T = location
Or
T = identifier
D... Tool offset number: 1...32000 (max., see machine manufacturer's specifications)
Parameters
T = location or identifier
T2 = identifier
Location or identifier, T triggers the tool change.
Extended address, tool for spindle 2
T0
Magazine location not occupied
D = offset
1 to n (n ≤ 32000)
If the relative D No. structure with internal reference to the
associated tools is used, replacement tool management and
monitoring function are possible.
D0
no offsets active!
To Next Page
Loading...
